1978 Jeep J10

Up for sale is a 1978 Jeep J10. Next year at college is going to be a little tight so figured Id try to get some cash for it or if not just keep it and rebuild it ground up when I'm setting better financially. It is a 1/2 ton short box, the jeep itself is grey with a grey and black interior. I bought it from a kid who needed the money last year and I've just been finding bits and pieces to add since then. It originally had a 401 BB, manual trans. That was gone when I bought it and it now runs a chevy 350 small block and a Turbo 350 trans mated to a np205 transfer-case. The motor has had a fair amount of work done to it, I bought this from another friend its a 4 bolt main small block with a stock crank and to my knowledge stock pistons, its stuffed with a 292 degree comp extreme 4x4, wieland Team G single plane intake, 650 cfm edelbrock carb with spacer, HEI Accel distributer, finned holly valve covers, high flow oil pump, new starter and flex plate as of 5/25/10, dynamax full length headers that run through 3'' pipe to afterburner mufflers.... I'll fill in the rest if you have a question you can email me. A while before I bought it someone swapped axles with a Jeep J20 so its an 8 lug pattern dana 60 limited slip rear, and a HD dana 44 front. To my knowledge it has about 9 to 10 inches of lift thanks to a spring over, rancho 4 inch lift springs in front, remounted perches in the rear, and 3 inches of body lift. Im not sure what kind of wheels they are got them from another friend, I do know they are new 16.5 maybe eagle alloys? they're wrapped with goodyear military OZ bias plys... talk about a gnarly tire. They have about 6000 miles on them, so basically new. The interior has a set of bucket seats out of a cop car that was totaled aftermarket add in gauges. This is a great truck and would be even better if someone has more time for it than me. Very minimal rust in usual Jeep places mostly surface. Has about a 2 week old Ultimate Linings bed-liner sprayed professionally at a dealership here in Sheridan along with a brand-new diamond plate tool box both of those combined were about $900! Its been a reliable daily driver so far this year! Talk about a truck that will go anywhere. Just remember its a Jeep, expect to work on it. As of now everything works great but a few lights and 3 of the factory gauges, thats where the aftermarket ones come in. I'm asking $1500 obo. Serious Inquires only I dont need to sell this but id like to, I have lots of hours in it and more money than I'm selling it for.


Tell your friends this Jeep is For Sale with your social network or email   Share   

Back to JeepTruck.com For Sale 

----- click on iamge to enlarge -----